Bobcat · Drive
Bobcat code D7501: Drive CAN joystick information error
What it means
The drive controller is getting bad or missing information from the joystick over the machine's data network.
Can I keep running?
Stop: fix before runningNo. Stop the machine safely (bucket or attachment down, engine off) and find the cause before you run it again.
Check first
- Park on level ground, lower the lift arms and attachment to the ground, stop the engine and remove the key.
- Check battery voltage, then clean and tighten the battery cables and ground straps. Bobcat notes that loose or corroded grounds can set several codes at once.
- Inspect the joystick connector and harness at the base of the control for damage.
- Restart and see if the code comes back. If it does, stop and call your Bobcat dealer.
Likely causes
- Loose or damaged joystick connector or harness
- Low voltage or bad grounds
- Faulty joystick
The fix
Wiring and connector repairs fix many cases. Otherwise the joystick or drive controller needs a dealer diagnosis. Don't drive the machine with this code active.
Different code on your screen? Snap the display and Mechy reads it.
Questions
What does Bobcat code D7501 mean?
Drive CAN joystick information error. The drive controller is getting bad or missing information from the joystick over the machine's data network.
Can I keep running with D7501?
No. Stop the machine safely (bucket or attachment down, engine off) and find the cause before you run it again.
How do I fix Bobcat code D7501?
Wiring and connector repairs fix many cases. Otherwise the joystick or drive controller needs a dealer diagnosis. Don't drive the machine with this code active.
Sources
Code meanings vary by model, serial range and software. Confirm with your operator's manual or Bobcat dealer before replacing parts.
Snap the display and Mechy reads the code
Take a photo of the screen and the machine, say what it is doing, and get the checks and the fix as steps with moving drawings.
First guide free. No sign-up, no card.