Mechy Try it free

Bobcat · Fuel

Bobcat code 14-03: Fuel shutoff pull solenoid error OFF (older code)

What it means

On older Bobcat loaders and Toolcats with two-part codes, 14-03 is the fuel shutoff pull solenoid error OFF (M1403 on newer machines). The engine usually starts and dies after a few seconds.

Can I keep running?

Keep going carefully, fix soon

Usually, if the machine runs normally: finish the job carefully and fix it soon. Stop if the machine derates, overheats, loses power or the code comes with an alarm.

Check first

  1. Park on level ground, lower the lift arms and attachment to the ground, stop the engine and remove the key.
  2. Check the fuses and relays for that circuit using the fuse decal or the O&M manual.
  3. Inspect the connector and wires at the fuel shutoff solenoid on the engine for corrosion or looseness.
  4. Test the solenoid before you buy one; good solenoids with bad wiring set the same code.
  5. Restart and see if the code comes back. If it does, stop and call your Bobcat dealer.

Likely causes

  • Loose, dirty or corroded connector at the fuel shutoff solenoid
  • Failed fuel pull relay or fuse
  • Damaged wiring to the solenoid
  • Failed fuel shutoff solenoid

The fix

Cleaning or repairing the solenoid connector or wiring, or replacing the relay or solenoid, fixes it. Call your dealer if the wiring and relay check out.

Different code on your screen? Snap the display and Mechy reads it.

Related fuel codes

All Bobcat codes

Questions

What does Bobcat code 14-03 mean?

Fuel shutoff pull solenoid error OFF (older code). On older Bobcat loaders and Toolcats with two-part codes, 14-03 is the fuel shutoff pull solenoid error OFF (M1403 on newer machines). The engine usually starts and dies after a few seconds.

Can I keep running with 14-03?

Usually, if the machine runs normally: finish the job carefully and fix it soon. Stop if the machine derates, overheats, loses power or the code comes with an alarm.

How do I fix Bobcat code 14-03?

Cleaning or repairing the solenoid connector or wiring, or replacing the relay or solenoid, fixes it. Call your dealer if the wiring and relay check out.

Sources

  1. TractorByNet forum, 2012 Toolcat 5600 fuel solenoid issue (code 14-03)
  2. Bobcat Company, Diagnostic Service Codes list (fault codes PDF, 2020)
  3. Bobcat T450 Operation & Maintenance Manual 7250077 (2018), Diagnostic Service Codes

Code meanings vary by model, serial range and software. Confirm with your operator's manual or Bobcat dealer before replacing parts.

Snap the display and Mechy reads the code

Take a photo of the screen and the machine, say what it is doing, and get the checks and the fix as steps with moving drawings.

Use my photo

First guide free. No sign-up, no card.